DATA FIVE SYSTEMS, INC. supporting the Job Corps Program.

Data Five Systems
Center Review Software updates

The SETUP.EXE program will install the Center Review Software. To install the software, you can "OPEN" the SETUP.EXE file from its current location, or download it to your local disk drive and then "OPEN" it. After the software is installed, you should click on the new Icon. The first time you "run" the software you will be asked to select your center, verify your center's address, enter the software password provided by Data Five, and then select the "default" graphs you desire on your system. The "default" graphs are the graphs which will appear when run the OMS10 graphs with no special selections. (Usually, your default graphs will be your center, your regional office, and the national office). - SETUP.EXE

If you have previously installed the new Center Review Software on your computer, you can update the software using the following procedures.
Version: 3.014 - crs.app and adamsmenu.app

    # Right click on the program file at the end of the description of the update above.
    # When you see the next window select "Save Target As", you should change the saving location as C:\PROGRAM FILES\DATAFIVE
    # Click the "SAVE" button. You should be told that the "file already exists. Do you want to replace it?" - answer 'YES'.

If your data files for the Center Review software are located on a network drive (see documentation "using CRS in a network enviroment"), you may update the crs.app file to the network drive, (O:\CRSDATA for example) and all computer workstations on the network using the CRS will be automaticly updated with the new software version. To save the crs.app file to the network drive, follow the instructions below:

    # Left click on the program file (crs.app) at the end of the description of the update above.
    # When you see the next window select "Save Target As", you should change the saving location as O:\CRSDATA where O: is the network drive letter for your center.
    # Click the "SAVE" button. You should be told that the "file already exists. Do you want to replace it?" - answer 'YES'.

OMS10 GRAPHS FOR 08/31/2008

The OMS10 Graphs use data which is extracted from the Data Center's OMS10 Reports. Since these reports are produced by the Data Center on a monthly basis, this system must update this this data after the Data Center has issued the new monthly reports. You must save the following two files to your computer to update the new OMS10 Data.   - OMSJCDC.DBF   OMSJCDC.CDX
    # RIGHT click on the program file at the end of the description of the update above.
    # Select "SAVE LINK AS"
    # When you see the window "Save As", you should change the saving location as:

C:\PROGRAM FILES\DATAFIVE\CRSDATA or

O:\CRSDATA where "O" is the network drive letter (if the data is installed on a network)

# Click the "SAVE" button. You should be told that the "file already exists. Do you want to replace it?" - answer 'YES'.
(you must do the steps above for both of the data files)